APC UPS BX650Li-MS (650VA/325W)
Battery and surge protected outlets - Back up and protect your hardware and data during power outages, surges and spikes.
Surge only outlets - Protect secondary electronics from surges and spikes without reducing battery power used to run primary electronics during an outage.
Automatic self-test - Periodic battery self-test ensures early detection of a battery that needs to be replaced.
Battery failure notification - Provides early-warning fault analysis on batteries enabling timely preventive maintenance.
Intelligent battery management - Maximizes battery performance, life, and reliability through intelligent, precision charging.
Resettable circuit breaker - Easy recovery from overloads; no need to replace a fuse.
Audible alarms - Provides notification of changing utility power and UPS power conditions
LED status display - Quickly understand unit and power status with visual indicators.
Safety-agency approved - Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.
Automatic Voltage Regulation (AVR)
Automatic Voltage Regulation boosts/trims the AC Voltage when it drops / exceeds safe levels. This allows the equipment plugged into the unit to operate during low / high voltage conditions, conserving the battery power in the event of a power cut.
The Back-UPS will switch to battery power if the input voltage level becomes too low / high for the Automatic Voltage Regulation to compensate, or if the AC power is distorted.
If the UPS is operating on battery power and detects that the connected equipment is using less than 15W of energy for more than 15 minutes, it will shutdown to conserve energy. When the UPS is reconnected to AC power, the UPS will automatically switch on.
650 VA/325 Watts
|Norminal Input Voltage:||
50/60 Hz ± 3 Hz (Auto sensing)
Maintenance-free sealed Lead-Acid battery with suspended electrolyte : leakproof
|Technical Recharge time:||
Stepped approximation to a sinewave
|Output Frequency ( Sync to mains ):||
50/60 Hz ±1 Hz
REACH: Contains No SVHCs